You are here: Products > TOOL CARRIER SYSTEMS > Mold Carriers > Pneumatic Mold Carriers

PNEUMATIC MOLD CARRIER FT06

  • This design distinguishes itself especially through its innovative kinematics, which on the one hand permits a wide opening of the upper platen and a free operation from three sides while on the other hand ensuring high clamping forces due to stable locking when closed. This design is used for small and medium-sized parts, such as for example automotive and aeroplane seat cushions. The vertical stroke and application of the clamping force are applied by air actuators in the base.

    The special advantages of the form carrier disk FT 06 are:

    • In relation to its clamping forces its design is very light and is therefore a low-cost design.
    • Free accessibility to the form from the top and from three sides.
    • Designed with clamping surfaces open (support profiles) or closed with aluminium table tops.
    • Adjustment of the under table either manually by means of a threaded spindle or optionally by a motorized spindle.
  • Measurements and Weights  
    Width 1.100 mm
    Depth 1.300 mm
    Height (closed state) 1.600 mm
    Height (open state) 1.800 mm
    Weight (without tool) 285 kg
    Installation dimensions/weights foam tools  
    Width 1.000 mm
    Depth 900 mm
    Height 300 mm
    Max. weight upper platen 70 kg
    Max. weight base 200 kg
    Clamping force (at 6 bar) 75 kN
    Carrier Movements  
    Parallel stroke base 150 mm
    Pivoting angle top 0º - 75º
    Pivoting angle base +/- 15º Fix adj.
    Cycle times  
    Closing times < 2 s
    Activation  
    All movements pneumatic

PNEUMATIC MOLD CARRIER FT08

  • The proven use of the currently smallest STEINER form carrier is over molding of the component parts with PUR. The pivoting base allows an ergonomic position for the operator and at the same time results in optimal ventilation.

    The clamping force is applied via a compact cylinder and two guide columns with longitudinal balance, to avoid thermal tension from heated forms.

    Special Advantages of the FT08 are:

    • Compact, lightweight (< 200kg) and thus cost-optimal design
    • Base and upper table independently pivoted
    • Lathering possible in both open and closed states
    • Continuous adjustment of the base is also possible by means of a motorized spindle
  • Measurements and Weights  
    Width 685 mm
    Depth 775 mm
    Height (closed state) 965 mm
    Height (open state) 1.375 mm
    Weight (without tool) 190 kg
    Installation dimensions/weights foam tools  
    Width 500 mm
    Depth 500 mm
    Height 140 mm
    Max. weight upper platen 40 kg
    Max. weight base 100 kg
    Clamping force (at 6 bar) 5 kN
    Carrier Movements  
    Parallel stroke base 50 mm
    Pivoting angle top 0º - 90º
    Pivoting angle base 0º - 40º
    Cycle times  
    Closing times < 2 s
    Activation  
    All movements pneumatic